Car Radio Repair - Car Radio Removal - Replace and Install Car Stereo

Hyundai Sonata Car Radio Removal and Replacement

	Hyundai Sonata Car Stereo Removal and Installation
	1.1) Gently pry insert from front of center console.
	2.1) Remove two exposed screws at each corner of opening.
	3.1) Gently pry gear shift trim ring from center console.
	4.1) Release connector at back of 12 volt supply socket.
	5.1) Remove two exposed screws from each side of center console.
	6.1) From passenger side of car, under dash, near center console, release securing latch on heater control cable.
	7.1) Release loop on end of heater control cable from shaft.
	8.1) Pull center dash trim panel from dash, pushing AC vents to down position will give a finger hold for pulling and releasing all clips.
	9.1) Disconnect connectors on bottom of trim panel.
	10.1) Pull trim panel forward, feeding AC control cable from dash. 10.2) Disconnect all connectors at center of trim panel releasing triggers.
	11.1) Disconnect all connectors at top of trim panel by releasing triggers.
	12.1) Pull trim panel forward from dash for better access.
	13.1) Disconnect remaining connectors from trim panel by releasing triggers.
	14.1) Remove four screws securing car stereo to dash.
	15.1) Pull car stereo from dash.
	16.1) Disconnect antenna and connectors by releasing trigger.
	17.1) After removing car stereo and trim panel, check to see if all trim panel clips were removed with the trim panel. In this case one clip remained behind.
	18.1) Feed clip from opening and remove.
	19.1) Re-insert clip on to trim panel.

Aftermarket Installation Tech Tips For installation of aftermarket car audio equipment and the Professional look, we suggest the Metra Installation Kit 99-7311 along with the Metra Wire Harness 70-7301. The wire harness is important! This will allow you to connect directly to the in dash factory car stereo wire harness with out splicing or cutting the factory wire harness.