Car Stereo Help Removal Guides |
How to Replace GMC Sierra and Yukon Manual Antenna and Cable | |
| Car Stereo Repair Home | Car
Stereo Removal | BOSE Repair | FAQ | Shipping | Top 10 | About Us |
||
 |
How to Replace GMC Sierra and Yukon Manual Antenna and Cable |
|
 |
1.1) For installation of new antenna mast only, see steps 11 and 12. 1.2) Open glove box. |
|
 |
2.1) Pull right side of glove box toward center of glove box. This will allow glove box stop to pass dash and release toward floor. | |
 |
3.1) Locate wire bundle in open on right side. | |
 |
4.1) Antenna coax cable may be taped into bundle, release cable and connector from bundle. | |
 |
5.1) Disconnect antenna cable at connector. | |
 |
6.1) At antenna mast, pry edge of small trim panel surrounding antenna mast releasing clip. All clips release with pry pressure. | |
 |
7.1) Continue prying across top of trim panel releasing clips. | |
 |
8.1) Pry edge of trim panel releasing clip. | |
 |
9.1) Lift trim panel from vehicle. | |
 |
10.1) Remove trim panel over antenna mast. | |
 |
11.1) With small wrench, loosen antenna mast. | |
 |
12.1) Unscrew antenna mast to remove. | |
 |
13.1) Use socket wrench to remove three mounting screws on antenna mast base. | |
 |
14.1) Lift hood of vehicle and locate antenna bass and coax cable. | |
 |
15.1) Reach into side opening along fender and pull coax cable from vehicle through rubber gromet. |
|
Car Stereo Repair Home | Car Stereo Removal | BOSE Repair | FAQ | Shipping | Top 10 | About Us Factory Car Stereo
Repair, Inc. |
||