Buick La Sabre How to Remove and Install Car Stereo
Buick La Sabre Car Stereo Removal and Installation 1.1) Remove panel releasing two clips. 2.1) Remove one exposed. 3.1) Remove panel releasing six clips. 4.1) Remove two exposed screw. 5.1) Turn AC vents to side to stop, then snap vent from pane. *NOTE - Vents will have two different size snaps, top and bottom and can only be reinstalled one way. 6.1) Remove four screws one in each vent cavity. 7.1) Set parking brake. 7.2) Turn ignition to on position and shift to low gear. 7.3) Remove dash panel by releasing four clips along top edge. 8.1) Remove three screws securing car stereo to dash. 8.2) Pull stereo forward, release antenna and connector.
	Factory Wire Color Codes See Diagrams Below
	Aftermarket Wire Color Codes See Diagrams Below
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up Speaker Phasing Font Left   Front Right + Tan   + Light green - Gray   - Dark green       Rear Left   Rear Right + Brown   + Dark blue - Yellow   - Light blue
	NO AUDIO With aftermarket stereo installation?
Buick LaSabre - Wire Diagrams - Wire Color Codes   Wire Diagrams, Cadillac, Chevrolet, Corvette, Geo, GMC, Oldsmobile, Pontiac and Saturn. DO NOT CUT FACTORY WIRE HARNESS     Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above. We discourage cutting the factory wire harness. This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons. Diagrams may not be applicable to Bose Audio Systems     IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts. 1   Gray Left Front Speaker (-) 2   Tan Left Front Speaker (+) 3   Dark Green Right Front Speaker (-) 4   Light Green Right Front Speaker (+) 5   Black Ground 6   Brown Illumination 7   Gray Dimmer 8   Blank   9   Yellow* (Green) Switched +12 volts 10   Orange Constant +12 volts 11   Light Blue Right Rear Speaker (-) 12   Dark Blue Right Rear Speaker (+) 13   Yellow Left Rear Speaker (-) 14   Brown Left Rear Speaker (+)     All wire diagrams and color codes are not 100% accurate.
Front and Rear Speaker Removal presently not available.
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You