Do It Yourself Buick Park Ave How to Remove Car Stereo
Buick Park Ave Car Stereo Removal and Replacement 1.1) At passenger side of car, begin pulling wood grains panel from dash, clips will release with pressure. 2.1) Work across dash removing wood grain panel. 3.1) Remove wood grain panel from dash. 4.1) Begin pulling wood grain panel from drivers side, left of steering column, panel clips will release with pressure. 5.1) Remove wood grain panel from dash. 6.1) Turn AC control vent left to stop. NOTE - When removing vents, place them in an order across the floor of the car so they get back to their correct locations properly. 7.1) Apply continuous pressure on AC vent to release from vent opening. Remove vent. 8.1) Remove one exposed screw at top of vent opening. 9.1) Remove one screw below AC vent exposed from wood grain panel removal. 10.1) Turn AC control vent left of car stereo, left to stop. 11.1) Apply continuous pressure on AC vent to release from vent opening. Remove vent. 12.1) Remove one exposed screw at top of vent opening. 13.1) Remove vent and exposed screw from right of car stereo. 14.1) Remove vent and exposed screw from passenger side of dash. 15.1) Remove one screw below AC vent exposed from wood grain panel removal. 16.1) Remove one to two more screws across dash exposed from wood grain panel removal. 17.1) Set parking brake and shift to low gear. 17.2) Gently pull dash trim panel from dash starting at passenger side of panel. 18.1) Work your way across dash, all panel clips release with pressure from removal. 19.1) Release all clips across entire dash on trim panel. 20.1) Lift panel up, away from dash, and set to side. 21.1) Remove three screws securing car stereo to dash. 22.1) Pull car stereo from dash. 23.1) Release trigger on main connector to release and remove antenna connector from car stereo.
	Factory Wire Color Codes See Diagrams Below
	Aftermarket Wire Color Codes See Diagrams Below
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up Speaker Phasing Font Left   Front Right + Tan   + Light green - Gray   - Dark green       Rear Left   Rear Right + Brown   + Dark blue - Yellow   - Light blue
	NO AUDIO With aftermarket stereo installation?
Buick Park Avenue - Wire Diagrams - Wire Color Codes   Wire Diagrams, Cadillac, Chevrolet, Corvette, Geo, GMC, Oldsmobile, Pontiac and Saturn. DO NOT CUT FACTORY WIRE HARNESS     Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above. We discourage cutting the factory wire harness. This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons. Diagrams may not be applicable to Bose Audio Systems     IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts. 1   Black Ground 2   Gray Dimmer 3   or Blank Antenna/Amplifier Trigger On 4   Yellow Switched +12 volts 5   Light Green Right Front Speaker (+) 6   Tan Left Front Speaker (+) 7   Gray Left Front Speaker (-) 8   Dark Green Right Front Speaker (-) 9   Brown Left Rear Speaker (+) 10   Dark Blue Right Rear Speaker (+) 11   Light Blue Right Rear Speaker (-) 12   Yellow Left Rear Speaker (-)     Factory Wire Harness On Factory Car Stereo   13     Orange Orange Constant +12 Volts 14     Brown Brown Illumination Corvette Only with Second One Wire Black Connector 15       Pink Bose Amplifier Trigger On     IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts. 1   Gray Left Front Speaker (-) 2   Tan Left Front Speaker (+) 3   Dark Green Right Front Speaker (-) 4   Light Green Right Front Speaker (+) 5   Black Ground 6   Brown Illumination 7   Gray Dimmer 8   Blank   9   Yellow* (Green) Switched +12 volts 10   Orange Constant +12 volts 11   Light Blue Right Rear Speaker (-) 12   Dark Blue Right Rear Speaker (+) 13   Yellow Left Rear Speaker (-) 14   Brown Left Rear Speaker (+)     All wire diagrams and color codes are not 100% accurate.
Front and Rear Speaker Removal presently not available.
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You