Do It Yourself Buick Regal Car Stereo Removal and Install
Buick Regal How to Remove and Replace Car Stereo 1.1) Gently pry panel insert from center console and disconnect connector. 2.1) Lift center console top insert up releasing clips and remove. 3.1) Remove two screws from center console. 3.2) Remove rubber insert from bottom of arm rest cavity and remove two screw. 4.1) Remove one screw on passenger side of car from bottom of side panel. 5.1) Remove fuse panel cover from side of dash. 6.1) Pull bottom side panel forward releasing clip and remove. 7.1) Remove one exposed screw from panel on passenger side of car. 8.1) Release plastic tab on drivers side of car at bottom of panel next to hood release. 9.1) Remove one screw at bottom of panel on drivers side next to center console. 10.1) Set parking brake, shift to low gear. 10.2) Surrounding assemble around gear shift has spring suspension, push down on forward edge while pulling center console toward back of car. For small clearance from dash. 11.1) Pull left side panel toward back of car releasing clips and set toward floor. 12.1) Gently pull entire dash trim from dash and around car stereo 12.2) Remove panel from car. 13.1) Remove screws securing car stereo to dash. 13.2) Pull car stereo from dash, disconnect antenna and connectors.
	Factory Wire Color Codes See Diagrams Below
	Aftermarket Wire Color Codes See Diagrams Below
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up Speaker Phasing Font Left   Front Right + Tan   + Light green - Gray   - Dark green       Rear Left   Rear Right + Brown   + Dark blue - Yellow   - Light blue
	NO AUDIO With aftermarket stereo installation?
Buick Regal - Wire Diagrams - Wire Color Codes   Wire Diagrams, Cadillac, Chevrolet, Corvette, Geo, GMC, Oldsmobile, Pontiac and Saturn. DO NOT CUT FACTORY WIRE HARNESS     Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above. We discourage cutting the factory wire harness. This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons. Diagrams may not be applicable to Bose Audio Systems     IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts. 1   Gray Left Front Speaker (-) 2   Tan Left Front Speaker (+) 3   Dark Green Right Front Speaker (-) 4   Light Green Right Front Speaker (+) 5   Black Ground 6   Brown Illumination 7   Gray Dimmer 8   Blank   9   Yellow* (Green) Switched +12 volts 10   Orange Constant +12 volts 11   Light Blue Right Rear Speaker (-) 12   Dark Blue Right Rear Speaker (+) 13   Yellow Left Rear Speaker (-) 14   Brown Left Rear Speaker (+)     All wire diagrams and color codes are not 100% accurate.
Front and Rear Speaker Removal and Replacement presently not available.
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You