Car Radio Repair - Car Radio Removal - Replace and Install Car Stereo

Cadillac Car Stereo Removal and Replacement

How to Remove Cadillac Seville
Car Stereo Help

Bose Amplifier, Front and Rear Speaker Removal presently not available.

Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up

NO AUDIO
With aftermarket stereo installation?

Erratic Volume Control
DIY Repair

Cadillac Eldorado CDM - Tuner / Receiver and Bose Amp Removal
	Cadillac Eldorado / Seville How to Remove and Install CDM Box (Location #1) 1.1) Pull rear panel down by releasing Velcro straps. 1.2) Remove rear panel.
	2.1) CDM box. 2.2) Release antenna and connectors from both sides of CDM box. 2.3) Remove 10mm nuts securing CDM box.
	3.1) CDM box locate at center of rear seat or toward right.
	4.1) CDM box.
	5.1) Removing rear Bose amplifiers only for repair, remove screws securing Bose amplifier to bottom of rear 6 x 9 speakers.

Cadillac Eldorado CDM - Tuner / Receiver Removal
	Cadillac Eldorado / Seville / STS CDM Box How to Remove and Install (Location #2) 1.1) Remove panel lining inside trunk exposing power antenna.
	2.1) Remove three 10mm nuts securing Tuner/Amplifier box behind power antenna. 2.2) Pull antenna cable from CDM box.
	3.1) Push CDM box from slide mount. 3.2) Disconnect all connectors.

Eldorado Front Bose Speaker Enclosure Remove and Install
	Cadillac Eldorado How to Remove and Replace Front Door Panel, Bose Speaker Enclosure
	1.1) Gently pry door controls from arm rest. 1.2) Remove exposed screw and remove connectors from arm rest controls.
	2.1) Gently pry trim from around door handle and remove connector.
	3.1) Pull down corner of carpet from door panel, releasing clip. 3.2) Remove exposed screw.
	4.1) Lift door panel straight up, releasing all hooks and remove.
	5.1) Remove screws securing Bose speaker enclosure with amplifier to door.
	6.1) Front Bose Speaker enclosure with enclosed amplifier.

Cadillac Eldorado and Seville Bose Amplifier Speaker Removal
	How to Remove and Install Rear Bose Enclosure with Amplifier and Speaker
	1.1) From trunk, pull rear panel down by releasing Velcro strips. 1.2) Drop rear panel and remove from car.
	2.1) Push rear bottom seat cushion from center of both seats toward back of car releasing latches on bottom of seat cushion from hook on floor. 2.2) Remove bottom of rear seat cushion from car.
	3.1) Remove bolts along bottom of rear upper seat cushion at seat belt mounts.
	4.1) From trunk, remove two nuts securing upper back of rear seat cushion.
	5.1) Pull rear seat cushion toward front of car to release and remove rear seat cushion from car. (Bolts, nuts removed from trunk in above step.)
	6.1) Pry two plastic clips from front edge of rear package shelf panel.
	7.1) Lift and remove package shelf panel from rear deck.
	8.1) Pry Bose speaker mounting trim from securing pin on rear deck.
	9.1) Pry opposite side of Bose speaker mounting trim from securing pin.
	10.1) Lift Bose speaker with trim and amplifier from rear deck. 10.2) Release trigger on connector from Bose amplifier to release. 10.3) When sending entire speaker with amplifier for repair, be sure to cover 6 x 9 speaker with cardboard to protect from damage during shipping.