2.1) Gently pull dash trim panel forward.
2.2) Disconnect connectors.
2.3) Lift right side of panel up allowing access to to car radio.
2.4) In some cases, the AC vent will unclip while removing panel. Set to
side and clip back into place on panel. Bottom left side of panel may have
to be inserted behind lower dash before placing panel back in place.
3.1) Push down on releases on each side of
car radio and pull forward to release from dash.
3.2) Disconnect antenna and connectors.
Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up
Troubleshooting Poor Reception and Antenna Replacement
NO AUDIO
With aftermarket stereo installation?
Factory Wire Color Codes
See Diagrams Below
Aftermarket Wire Color Codes
See Diagrams Below
Front and
Rear Speaker Removal and Replacement presently not available.
Aftermarket stereo installation?
Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver!Factory wire colors codes are not universal. See Aftermarket Videos above.
We discourage cutting the factory wire harness.
This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons.
Diagrams may not be applicable to Bose Audio Systems
1978 - 1992
IMPORTANT - There are two (2) yellow*, two (2) gray and two (2)
brown wires in this harness. Locate the +12 volt constant wire first.
Label it or splice to constant wire on aftermarket stereo first. Swapping
yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts.
1
Black
Ground
2
Gray
Dimmer
3
or Blank
Antenna/Amplifier
Trigger On
4
Yellow
Switched +12 volts
5
Light Green
Right Front Speaker (+)
6
Tan
Left Front Speaker (+)
7
Gray
Left Front Speaker (-)
8
Dark Green
Right Front Speaker (-)
9
Brown
Left Rear Speaker (+)
10
Dark Blue
Right Rear Speaker (+)
11
Light Blue
Right Rear Speaker (-)
12
Yellow
Left Rear Speaker (-)
Factory Wire Harness
On
Factory Car Stereo
13
Orange
Orange
Constant +12 Volts
14
Brown
Brown
Illumination
Corvette Only with Second One Wire
Black Connector
15
Pink
Bose Amplifier Trigger
On
1988 - 2005
IMPORTANT - There are two (2) yellow*, two (2) gray and two (2)
brown wires in this harness. Locate the +12 volt constant wire first.
Label it or splice to constant wire on aftermarket stereo first. Swapping
yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts.
1
Gray
Left Front Speaker (-)
2
Tan
Left Front Speaker (+)
3
Dark Green
Right Front Speaker (-)
4
Light Green
Right Front Speaker (+)
5
Black
Ground
6
Brown
Illumination
7
Gray
Dimmer
8
Blank
9
Yellow* (Green)
Switched +12 volts
10
Orange
Constant +12 volts
11
Light Blue
Right Rear Speaker (-)
12
Dark Blue
Right Rear Speaker (+)
13
Yellow
Left Rear Speaker (-)
14
Brown
Left Rear Speaker (+)
All wire diagrams and color codes are not 100% accurate.