Chevrolet Camaro Rear Bose Amplifier Removal
	Chevrolet Camaro Rear Bose Amplifier Removal and Repair
	1.1) Gently pull plastic trim from rear deck.
	2.1) Two clips will release with pressure when panel is removed.
	3.1) Repeat for opposite small plastic trim.
	4.1) Remove all exposed screws.
	5.1) Remove speaker grill cover.
	6.1) Lift rear deck up, while still in car. 6.2) Release trigger on connector to disconnect.
	7.1) Slide connector to side, the connector will release from panel.
	8.1) Remove four screws securing speaker.
	9.1) Lift speaker from deck.
	10.1) Remove speaker and Bose amplifier.
	11.1) Feed released connector through opening to remove.
Chevrolet Camaro Car Stereo Removal and Install
	1) Remove four torx screws from the dash trim bezel and remove bezel. 2) Remove four screws securing factory car stereo. 3) Pull car stereo forward, disconnect antenna and connectors.
	Factory Wire Color Codes See Diagrams Below
	Aftermarket Wire Color Codes See Diagrams Below
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up
	NO AUDIO With aftermarket stereo installation?
	Erratic Volume Control DIY Repair
Wire Diagrams, Cadillac, Chevrolet, Corvette, Geo, GMC, Oldsmobile, Pontiac and Saturn. DO NOT CUT FACTORY WIRE HARNESS     Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above. We discourage cutting the factory wire harness. This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons. Diagrams may not be applicable to Bose Audio Systems     1978 - 1992 IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts. 1   Black Ground 2   Gray Dimmer 3   or Blank Antenna/Amplifier Trigger On 4   Yellow Switched +12 volts 5   Light Green Right Front Speaker (+) 6   Tan Left Front Speaker (+) 7   Gray Left Front Speaker (-) 8   Dark Green Right Front Speaker (-) 9   Brown Left Rear Speaker (+) 10   Dark Blue Right Rear Speaker (+) 11   Light Blue Right Rear Speaker (-) 12   Yellow Left Rear Speaker (-)     Factory Wire Harness On Factory Car Stereo   13     Orange Orange Constant +12 Volts 14     Brown Brown Illumination Corvette Only with Second One Wire Black Connector 15       Pink Bose Amplifier Trigger On     1988 - 2005 IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts. 1   Gray Left Front Speaker (-) 2   Tan Left Front Speaker (+) 3   Dark Green Right Front Speaker (-) 4   Light Green Right Front Speaker (+) 5   Black Ground 6   Brown Illumination 7   Gray Dimmer 8   Blank   9   Yellow* (Green) Switched +12 volts 10   Orange Constant +12 volts 11   Light Blue Right Rear Speaker (-) 12   Dark Blue Right Rear Speaker (+) 13   Yellow Left Rear Speaker (-) 14   Brown Left Rear Speaker (+)     All wire diagrams and color codes are not 100% accurate.
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You