Tahoe Car Stereo and Speaker Removal and Install
	Chevrolet Tahoe How to Remove and Install Car Stereo
	Chevrolet Tahoe Front Door Speaker Removal and Replacement
	Chevrolet Tahoe Rear Door Speaker Removal and Replacement
	Factory Wire Color Codes
	Aftermarket Wire Color Codes
	Front and Rear Speaker Removal and Replacement Front Speaker Phasing Font Left   Front Right + Tan   + Light green - Gray   - Dark green Rear Speaker Phasing Rear Left   Rear Right + Brown   + Dark blue - Yellow   - Light blue
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up
	NO AUDIO With aftermarket stereo installation?
	Erratic Volume Control DIY Repair
Chevrolet Tahoe Tweeter Removal and Replacement Chevrolet Tahoe How to Remove and Install Front Tweeter 1.1) At top edge of side pillar trim panel, pry edge of panel from pillar releasing clips. All clips release with pressure. 2.1) Pull top edge of panel back to release all clips along back of panel. 3.1) Lift bottom edge of panel up to release two tongues into lower dash panel. 4.1) Pull top edge of panel down for access to back of panel. 5.1) Release trigger on connector to disconnect. 6.1) Remove side pillar panel with tweeter. 7.1) Pry clip at edge of panel at tweeter. 8.1) Release tweeter and remove. 9.1) Check pillar for any remaining panel clips. 10.1) Pry clips from pillar to remove. 11.1) Push clip onto side pillar panel ready for reinstallation.
Chevrolet Tahoe Rear Side Tweeter Remove and Replace Chevrolet Tahoe How to Remove and Replace Rear Side Tweeter 1.1) Open rear hatch. 1.2) Pry trim panel along top of opening from roof releasing clips. All clips release with pry pressure. 2.1) Work across top trim panel releasing clips. 3.1) Remove trim panel and set to side. 4.1) Pry rear edge of side tweeter panel releasing clips. 5.1) Work down side of panel releasing clips. 6.1) Work down side of panel to bottom releasing clips. 7.1) Grasp edge of released panel an pull forward toward front of vehicle releasing remaining clips. 8.1) Pull panel slightly to side for access to back of panel. 9.1) Release trigger on connector at tweeter to disconnect and remove. 9.2) Set tweeter panel to floor of vehicle to continue. 10.1) Pry up under edge of tweeter to releasing clip. 11.1) Lift released edge of tweeter up and back to release opposite edge of tweeter. 12.1) Remove tweeter.
Chevrolet Tahoe Subwoofer     Amplifier Location Open glove box and release to full down position. The amplifier is located behind the glove box. The amplifier is mounted to a bracket. At the top of the amplifier is s spring clip that holds the amplifier to the bracket. A flat head screw driver can release the spring clip. The amplifier can be released from the bracket. However, we were unable to twist, turn or move the amplifier into a position to be removed from the dash. Our best guess, dash removal to remove the amplifier.
Wire Diagrams, Cadillac, Chevrolet, Corvette, Geo, GMC, Oldsmobile, Pontiac and Saturn. DO NOT CUT FACTORY WIRE HARNESS     Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above. We discourage cutting the factory wire harness. This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons. Diagrams may not be applicable to Bose Audio Systems     IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts.     1988 - 2005 IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts. 1   Gray Left Front Speaker (-) 2   Tan Left Front Speaker (+) 3   Dark Green Right Front Speaker (-) 4   Light Green Right Front Speaker (+) 5   Black Ground 6   Brown Illumination 7   Gray Dimmer 8   Blank   9   Yellow* (Green) Switched +12 volts 10   Orange Constant +12 volts 11   Light Blue Right Rear Speaker (-) 12   Dark Blue Right Rear Speaker (+) 13   Yellow Left Rear Speaker (-) 14   Brown Left Rear Speaker (+)     All wire diagrams and color codes are not 100% accurate.
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You