How to Removing and Installing Car Stereo for
Chrysler LHS
1.1) Gently pry trim panel from dash
releasing clips.
1.2) Disconnect connector from A/C control and set panel to side.
2.1) Remove four screws securing car stereo
to dash.
2.2) Pull car stereo forward, disconnect antenna and connectors.
2.3) For FOUR CD CHANGER, remove two screws securing changer.
2.4) Pull CD changer forward, disconnect connector.
Afermarket
Car Stereo Install
Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up
NO AUDIO
With aftermarket stereo installation
Chrysler LHSCenter Dash Tweeter Replacement
Chrysler LHS
Center Dash Tweeter Removal and Installation
1.1) Gently pull rubber trim from side of
window jam.
2.1) Gently pull panel from between wind
shield and front door, pulling bottom edge that meet dash back to unlock
and remove.
2.2) REPEAT THESE FIRST TWO STEPS FOR BOTH SIDES OF CAR.
3.1) Gently pry forward dash panel up, pull
toward back of car to release forward edge.
4.1) Remove screws securing center tweeter to
dash and disconnect connector.
Chrysler LHS
Front Door Speaker Removal
How to Remove Front Door Speakers for
Chrysler LHS
1.1) At leading edge of speaker
grill, apply pressure toward back edge of grill releasing leading edge.
1.2) Gently remove grill cover.
2.1) Factory speaker is 6 3/4"
mounted to special factory bracket.
2.2) Remove three screws securing speaker and bracket.
2.3) Also shown is aftermarket bracket for mounting 5 1/4" or 6 1/2"
speaker.
*NOTE - These speaker adaptors are available at local
shops.
3.1) Installed 6 1/2" speaker
with bracket.
Remove and Install Front Door Speakers
- Tweeter for Chrysler LHS
1.1) Remove two screws from frame of tweeter.
2.1) Release tweeter cover with
tweeter.
2.2) Disconnect connector and remove.
Chrysler LHS
Rear Deck Speaker Removal
How to Remove Rear Deck Speakers for
Chrysler LHS
1.1) Place fingers at rear edge
of speaker grill.
2.1) Pull rear edge of speaker
grill toward front up car and lift back edge up.
3.1) Remove speaker grill from
rear deck.
4.1) Remove four screws securing
rear deck speaker.
4.2) Lift speaker and disconnect connector.
Chrysler LHS Infinity Amplifier Removal
How to Remove and Install Infinity
Amplifier for Chrysler LHS
1.1) Remove two plastic panel pins securing
side panel.
1.2) Pull side panel down for access.
1.3) Remove four screws securing Infinity Amplifier to body frame.
2.1) Remove Infinity Amplifier from cavity
and disconnect connectors.
