Dodge Magnum Car Audio - Stereo and Speakers
How to Remove Dodge Magnum Car Stereo 1.1) Gently pry dash panel at right side to release clips. All clips release with pressure. 2.1) Gently pry dash panel at left side to release clips. 3.1) Pull front dash panel forward.   4.1) Release triggers on connectors at AC control to disconnect. 5.1) Release trigger on connector at top of dash panel to disconnect. 5.2) Remove dash panel and set to side. 6.1) Remove one screw bottom left of car stereo. 7.1) Remove one screw top left of car stereo. 8.1) Remove one screw bottom right of car stereo. 9.1) Remove one screw top right of car stereo. 10.1) Pull car stereo from dash. 10..2) At smaller connector, release trigger to disconnect. 11.1) At larger connector, release trigger to disconnect. 12.1) Release antenna from car stereo.
Dodge Magnum Front Door Speaker Removal How to Remove Dodge Magnum Front Door Speaker 1.1) Gently pry bottom of screw cover up in door handle cavity. 2.1) Hold screw cover up. 3.1) Remove exposed screw with screw driver. 4.1) Along front edge of door panel. Push center pin of clip in with small screw driver. 5.1) Repeat, push center pin in on lower clip at front edge of door panel. 6.1) Place pry tool behind edge of door panel at lower clip and pry door panel from door releasing clip. 7.1) Place pry tool behind edge of door panel at upper clip and pry door panel from door releasing clip. 8.1) Remove one screw along lower front edge of door panel. 9.1) Remove one screw along bottom front edge of door panel. 10.1) Remove one screw along bottom center edge of door panel. 11.1) Remove one screw along bottom rear edge of door panel. 12.1) Along rear bottom edge of door panel. Push center pin of clip in with small screw driver. 13.1) Place pry tool behind edge of door panel at lower rear clip and pry door panel from door releasing clip. 14.1) Along rear edge of door panel. Push center pin of clip in with small screw driver. 15.1) Along rear edge of door panel. Push center pin of clip in with small screw driver. 16.1) Place pry tool behind edge of door panel at lower rear clip and pry door panel from door releasing clip. 17.1) Repeat for upper clip, place pry tool behind edge of door panel at lower rear clip and pry door panel from door releasing clip. 18.1) Under hand hold on door panel, gently pry top of screw cover from door panel. 19.1) Remove exposed screw. 20.1) Pull bottom of door panel from door, lift top back edge of door panel up out of window jam to release. Lift from top edge of door panel up out of window jam to release. 21.1) Reach behind door panel and locate door handle linkage. 22.1) Turn small plastic clip from linkage to release. 22.2) Lift linkage up out of small opening to release from door panel. 23.1) Release wires from door panel at panel clip. 24.1) Release trigger on connector at control panel to disconnect. 25.1) Remove screws securing car speaker to door panel.
Dodge Magnum Rear Speaker Removal How to Remove Dodge Magnum Rear Speaker 1.1) Remove one screw from top edge of speaker cover panel. 2.1) Gently pry front edge of speaker cover panel up releasing clips. All clips release with pressure. 3.1) Grasp speaker cover panel and pull toward front of car releasing rear lock tabs. 4.1) Remove speaker cover panel and check to see if both clips are secured to panel. Set panel to side. 5.1) Remove screws securing speaker to remove. NOTE - for determining aftermarket installation polarity of speaker wires for correct hook up see Speaker Phasing below.     How to Remove Dodge Magnum Front Dash Speaker 1) Gently pry rear edge of speaker grill from front dash. 2) Remove speaker grill. 3) Remove screws securing speaker and remove.
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up
	NO AUDIO With aftermarket stereo installation
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You