Honda Odyssey Removing and Installing Navigation and Stereo
	Honda Odyssey Car Stereo Removal Navigation screen does not flip up? This problem can be cause by a defective CD Changer
	Honda Odyssey CD Changer Jammed Navigation Screen Stuck Down
	Honda Odyssey Wire Color Codes
	Aftermarket Car Stereo Wire Color Codes and Hook Up
	Radio CodE
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up
	NO AUDIO With aftermarket radio installation?
	DIY Repair Erratic Volume Control
Honda Odyssey Car Stereo Removal and Install Honda Odyssey Car Stereo Removal (Mid Dash) 1.1) Gently pry edge of gear shift/AC panel from dash releasing clips. All clips release with pry pressure. 2.1) Continue along edge of panel releasing clips. 3.1) Continue along edge of panel releasing clips. 4.1) Continue along edge of panel releasing clips. 5.1) Continue along edge of panel releasing clips. 6.1) Continue along edge of panel releasing clips. 7.1) Lift panel from dash for access to wire harnesses. 8.1) Locate connector between AC vents. 9.1) Squeeze trigger on connector into connector to release and remove. 10.1) Locate second connector. 11.1) Squeeze trigger on connector into connector to release and remove. 12.1) Remove remaining connectors to panel. 13.1) Remove panel and set to side. 14.1) Remove two exposed mounting screws above car stereo. 15.1) Pry left side of car stereo trim panel from dash releasing clip. 16.1) Pry right side of car stereo trim panel from dash releasing clip. 17.1) When reinstalling car stereo, locate clip on stereo trim panel. 18.1) Clip mates to opening in dash, push car stereo into place to lock and install mounting screws. 19.1) Pull car stereo from dash. 20.1) In some cases, the car stereo can not be removed completely from dash. Locate first connector on back of car stereo. 20.2) Squeeze triggers on each connector into connector to release and remove. 21.1) Remove car stereo from dash.
Odyssey CD and Navigation Screen Removal and Install Honda Odyssey CD Changer and Navigation Screen Removal (Upper Dash) 1.1) Gently pry edge of gear shift/AC panel from dash releasing clips. All clips release with pry pressure. 2.1) Continue along edge of panel releasing clips. 3.1) Continue along edge of panel releasing clips. 4.1) Continue along edge of panel releasing clips. 5.1) Continue along edge of panel releasing clips. 6.1) Continue along edge of panel releasing clips. 7.1) Lift panel from dash for access to wire harnesses. 8.1) Locate connector between AC vents. 9.1) Squeeze trigger on connector into connector to release and remove. 10.1) Locate second connector. 11.1) Squeeze trigger on connector into connector to release and remove. 12.1) Remove remaining connectors to panel. 13.1) Remove panel and set to side. 14.1) Below upper trim panel, remove one exposed screw bottom left side. 15.1) Below upper trim panel, remove one exposed screw bottom right side. 16.1) Between AC vents, below trim panel, locate screw at back of opening. 17.1) With a long screw driver, remove screw. 18.1) Pull left side of trim panel from dash releasing clips. 19.1) Pull right side of trim panel from dash releasing clips. 20.1) Pull trim panel with Navigation screen and CD changer from dash releasing remaining clips. 21.1) Remove Navigation screen and CD changer from dash. 22.1) At back of CD changer, locate trigger on connector. 23.1) Squeeze trigger into connector to release and remove. 24.1) Locate trigger on second connector. 25.1) Squeeze trigger into connector to release and remove. 26.1) At back of Nav screen, locate trigger on connector, release and remove. 27.1) Release and remove second connector at Nav screen. 27.2) Remove Nav screen and CD changer, separate from brackets to remove.
Honda Odyssey DVD Player Removal and Replacement Honda Odyssey DVD Player Removal and Install 1..1) Open drink tray. 2.1) Remove screw bottom right in drink holder opening. 3.1) Remove screw bottom left in drink holder opening. 4.1) Left side of center console, pry center tab of clip from panel. 5.1) Center tab on clip release approximately 1/4 inch from base of clip releasing lock down, remove clip. 6.1) Note - Clip as it is installed on panel in lock down. 7.1) Note - Center tab on clip released 1/4 inch from base. This allows entire clip to be removed from panel. 8.1) Note - when reinstalling clip, push clip into opening on panel, push tab flush to lock clip into place. 9.1) Pull bottom front edge of panel from center console releasing clip. 10.1) Pull side panel toward rear of vehicle to release panel from pin at front of vehicle. 11.1) Note - When reinstalling side panels, pin at front of vehicle through opening in panel before snapping clip into place. 12.1) Remove exposed screw from side panel removal. 13.1) Passenger's side of center console, pry center tab of clip from base. 14.1) Remove entire clip from panel. 15.1) Pull front edge of panel from center console releasing clip. 16.1) Pull panel toward rear of vehicle and remove panel. 17.1) Remove exposed screw from side panel removal. 18.1) Grasp back edge of lower dash panel and pull toward rear of vehicle to release clips. 19.1) Driver's side, grasp back edge of lower dash panel and pull toward rear of vehicle to release clips. 20.1) Pull panel forward from dash. 21.1) Right side of DVD player, locate plastic clip securing wire harness. 22.1) With a pair of pliers, squeeze top of plastic clip. 23.1) Plastic clip will release down through opening, this will allow for several inches of play in wire harness for following steps. 24.1) Pull front dash panel forward for access to connectors. 25.1) Squeeze trigger on first connector into connector to release and remove. 26.1) Grasp second connector. 27.1) Wiggle connector to release and remove. 28.1) Grasp third connector. 29.1) Wiggle connector to release and remove. 30.1) Squeeze trigger on connector into connector to release. 31.1) Remove connector. 32.1) Remove panel and set to side. 33.1) Remove lower right mounting screw from DVD player. 34.1) Remove upper right mounting screw from DVD player. 35.1) Remove lower left mounting screw from DVD player. 36.1) Remove upper left mounting screw from DVD player. 37.1) Pull DVD player from dash. 38.1) Squeeze trigger on connector into connector to release. 39.1) Remove connector. 39.2) Remove DVD player.
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You