Car Radio Repair - Car Radio Removal - Replace and Install Car Stereo

Remove and Install Hyundai Accent Car Stereo

	Hyundai Accent Car Stereo Removal
	1.1) Remove ash tray.
	2.1) Remove exposed screws from ash tray removal
	3.1) From under dash, driver side, (brake pedal is shown at left of this picture). 3.2) At upper cable, push small pin to release metal loop from lever.
	NOTE - In some cases you may find your self getting frustrated over these instructions. Skip to the cable removal instructions for behind the glove box. There is easier access and you will become more familiar with the process. 4.1) Follow cable back to securing bracket. 4.2) Push clip up to release cable.
	5.1) Repeat process from above for lower AC cable. 5.2) Find small pin to release cable loop.
	6.1) Remove cable loop.
	7.1) Follow cable back to securing bracket. 7.2) Push clip down to release cable.
	8.1) Two released AC cables.
	9.1) Open glove box, push sides of glove box in to allow stops to pass and lower to full down position.
	10.1) Release third AC cable loop, same as above.
	11.1) Follow cable back to securing bracket. 11.2) Push clip down to release cable.
	12.1) Released third AC cable.
	13.1) Gently pull dash trim panel with AC controls from dash.
	14.1) You may have to feed AC control cable back into dash to allow panel to come forward.
	15.1) Reach behind panel. 15.2) Release triggers on connectors at top of control panel to disconnect.
	16.1) Pull top of panel down to allow access to mounting screws on sides of car stereo. NOTE - Don't remove dash trim panel, it is more difficult to route AC cables during installation.
	17.1) Remove car stereo.
	18.1) Remove antenna and release trigger on connector to disconnect.
	Aftermarket Car Stereo Installation Metra wire harness 70-7300 No installation kit needed 1.1) Splice car stereo harness to Metra wire harness. In most cases, these wires mate color for color.
	2.1) Remove brackets from factory car stereo. 2.2) Mount factory bracket to sides of aftermarket car stereo with mounting hardware supplied with aftermarket car stereo. Length of screw is important.
	3.1) Mate Metra and car stereo wire harness to factory wire harness in dash.
	4.1) Install connector into back of car stereo. 4.2) Install antenna lead into back of car stereo.