Do It Yourself Removing Lincoln Town Car Front Speakers
Lincoln Town Car How to Remove Front Speaker 1.1) Remove two screws from under door handle pull. 2.1) Remove door handle pull and remove two exposed screws. 3.1) Remove one screw hidden in bottom rear corner of door panel. 4.1) Remove one screw hidden in bottom front corner of door panel. 5.1) Gently pry front edge of control panel up and pull forward to release rear latch. 5.2) Disconnect connector. 6.1) Pull door panel from door starting at bottom and working up both sides. 6.2) Remove screws securing car speaker to door panel.
Lincoln Town '98-99 Car Stereo Removal and Installation Lincoln Town '98-99 How to Remove and Install Car Stereo Direction "Din Tools" Din Tools can be purchased at a local Auto Parts Store. They are Ford Car Stereo removal tools. 1) Insert "Din tools" into holes on both sides of radio. 2) Push tools slightly to the outside of the car stereo, this releases the lock mechanism, pushing them to the side of the car stereo. 3) Pull unit forward from dash. 4) Remove antenna and connectors.
Lincoln Town Car How to Remove and Install Car Rear Speaker Direction 1) Push edge of speaker grill toward middle of speaker releasing side latches and lift up 1) Remove grill cover and remove screws securing car speaker.
Lioncoln Power Antenna Mast Replacement These instructions work only if your the power antenna motor runs when the car stereo is turned on and off. Purchase a new mast from the dealership. Lincoln Power Antenna Mast Removal and Installation Instructions 1) With needle nose pliers, insert nose into slots on nut at top of antenna base. 1) Remove nut and base from antenna mast. 2) Turn car stereo on, remove antenna mast and nylon cable by pulling from power motor assembly. *NOTE - Measure length of new antenna mast against old antenna mast. (In this picture, there is no nylon cable attached to mast). If they match in length, insert new mast and turn stereo off. Feed nylon cable into motor. Install mast base and nut. If they do not match in length continue with instructions. Turn car stereo on/off for testing. 1) Remove two plastic side panel tabs from panel. 1) Pull side panel from car, feeding manual gas flap release through panel. 1) Disconnect antenna cable and connectors from power antenna assembly. 2) Remove bolts securing power antenna motor assembly. 1) Place antenna motor assembly on flat ground for disassembly. 1) Remove cover from power antenna motor assembly. 1) Remove gear assembly. 2) Remove nylon cable from cover. 3) Inspect power assembly for debris and pieces of nylon cable. 4) Reassemble and assembly into car. 5) Turn car stereo one, allow power antenna to cycle, feed nylon cable into antenna and turn car stereo off. 6) Install antenna base and nut.
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up
	NO AUDIO With aftermarket stereo installation?
	Erratic Volume Control DIY Repair
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You