Mazda 929 Removing, Replacing and Installing Speakers
Mazda 929 How to Car Stereo Removal and Installation 1) From behind car stereo in dash, remove two 10mm bolts across back of stereo. 2) Push car stereo forward from dash. 3) Disconnect antenna and connectors.
	Color Codes for Aftermarket Installation Factory Wire Harness Codes Below
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up
	NO AUDIO With aftermarket stereo installation?
	Erratic Volume Control DIY Repair
Mazda 929 Front Right Speaker Removal and Installation 1.1) Gently pry on edge of side plate to release clips and remove. 2.1) Remove two exposed screws securing plate over speaker. 3.1) Remove screws along top and bottom edge of speaker panel cover. 3.2) Remove cover panel. 4.1) Remove four screws securing speaker.     Front Left Speaker Removal, Replacement and Installation 1.1) Pull weather stripping from door jam. 2.1) Gently pry edge of side panel away from dash and pull toward back of car to release front latches. 3.1) Remove two exposed screws from panel. 4.1) Loosen bolt on hood latch behind front dash and release from mount and face of panel. 4.2) Remove under dash panel and replace speaker.
Mazda 929 Rear Deck Speaker Removal and Replacement Mazda 929 How to Remove and Install Rear Deck Speakers 1.1) Release two clips at leading edge of bottom seat cushion and remove cushion. 2.1) Remove two bolts, one at each side of rear seat cushion. 3.1) Remove two screws in seat belt holder pocket. 4.1) Lift rear seat cushion straight up to release from three hooks and remove cushion. 5.1) Remove two plastic anchors from third brake light. Push center tab "in" releasing anchor and remove. 6.1) Remove cover from third brake light. 6.2) Remove screws securing third brake light assembly, disconnect connector and remove. 7.1) Remove two screws securing third brake light mounting bracket and remove bracket. 8.1) With pry tool, remove all plastic clips from rear deck panel. 9.1) Gently lift rear deck panel up from center and pull toward front of car to remove. 10.1) Remove screws securing rear sub woofer speaker to rear deck. (Foam surround on this speaker is deteriorated, many local speaker shops can repair.)
Mazda 929 '88-91 Rear Door Speaker Removal and Installation 1.1) Remove two screw covers on each side of door panel and remove exposed screws. 2.1) With pry tool, release clips along bottom half of door panel. *NOTE - we cheated on this one! 3.1) While laying on ground, with help to hold panel back. Remove screws securing speaker to door with stubby or 90 degree screw driver.
Mazda 626 Car Audio - Wire Diagrams - Wire Color Codes   DO NOT CUT FACTORY WIRE HARNESS     Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above. We discourage cutting the factory wire harness. This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons.     Diagram 1   Diagram 2   Diagram 3   Wire diagrams may not be 100% accurate for your vehicle.
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You