Car Radio Repair - Car Radio Removal - Replace and Install Car Stereo

Mazda Miata DIY Removing and Installing Car Radio

Mazda Miata How to Remove and Install Car Stereo

Aftermarket Audio Adaptor Installation after Removal
	Auxiliary Audio Input Adaptor Install and Hook Up Control Box MAZ/PC-ALP Wire Harness ALP/M-RCA
	1.1) Remove contents from both packages. 1.2) Install wired adaptor into control box.
	2.1) Plug connector from control box into CD changer slot on back of car stereo.
	3.1) Run end of wired adaptor to either side of center console. 3.2) Tuck control box back into car stereo cavity, allow room for car stereo installation.

Color Codes for Aftermarket Installation

Factory Wire Harness Codes
Below

Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up

NO AUDIO
With aftermarket stereo installation?

Erratic Volume Control
DIY Repair

	Mazda Miata How to Remove and Install Front Door Panel
	1.1) Pry center of panel pin away from door panel. (This is similar to a wall anchor.)
	2.1) Remove entire panel clip/pin from door panel.
	3.1) Repeat above steps for two panel clips/pins along back edge of door panel.
	4.1) Repeat above steps for two panel clips/pins along back edge of door panel.
	5.1) Remove one screw from door handle.
	6.1) Remove screw from door open pull cavity and remove panel.
	7.1) Remove hidden screw under carpet cover in hand hold.
	8.1) Pull door panel from door, up and out of window jam. 8.2) Disconnect connector at tweeter.
	9.1) Four screws secure Bose subwoofer to door panel. Speaker can be purchased from dealership.

Mazda Car Audio - Wire Diagrams - Wire Color Codes

DO NOT CUT FACTORY WIRE HARNESS

Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above.
We discourage cutting the factory wire harness.
This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons.

Diagram 1


Diagram 2


Diagram 3


Wire diagrams may not be 100% accurate for your vehicle.

Front and Rear Speaker Removal and Replacement presently not available.