Car Radio Repair - Car Radio Removal - Replace and Install Car Stereo

Mitsubishi Lancer Car Audio Remove and Replace

Mitsubishi Lancer
Car Stereo Removal and Replacement

Mitsubishi Lancer
Front Speaker Removal and Replacement

Rear Speaker Removal below

Aftermarket Car Stereo
Wire Harness

Factory Wire Harness Codes
Below

Factory Wire Harness, Color Codes and Aftermarket Installation

Factory Wire Harness Codes
Below

Speaker Phasing
Installing Aftermarket Speakers and Proper Hook-up

NO AUDIO
With aftermarket stereo installation?

Erratic Volume Control
DIY Repair

Mitsubishi Lancer Rear Speaker Removal and Install
	Mitsubishi Lancer Rear Deck Speaker Removal and Replacement
	1.1) From the trunk side of the rear speaker.
	2.1) First white tab to side of speaker, squeeze tab to release lock.
	3.1) While squeezing tap, pushing up to release through small opening on rear deck.
	4.1) Push tab up to keep from locking back into place.
	5.1) Second white tab, repeat release procedure.
	6.1) Third white tab, repeat release procedure.
	7.1) From top of rear deck, grasp speaker grill.
	8.1) Remove speaker grill and set to side.
	9.1) Remove four screws securing speaker to rear deck.
	10.1) Lift speaker from rear deck.
	11.1) Release trigger on connector to disconnect, remove speaker. NOTE - for determining aftermarket installation polarity of speaker wires for correct hook up see Speaker Phasing above.

Factory Wire Harness Codes

DO NOT CUT FACTORY WIRE HARNESS

Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above.

We discourage cutting the factory wire harness.

This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons.

Diagram 1