Oldsmobile Intrigue Removing and Installing Car Radio
	Factory Wire Color Codes See Diagrams Below
	Aftermarket Wire Color Codes See Diagrams Below
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up Speaker Phasing Font Left   Front Right + Tan   + Light green - Gray   - Dark green       Rear Left   Rear Right + Brown   + Dark blue - Yellow   - Light blue
	NO AUDIO With aftermarket stereo installation?
	Erratic Volume Control DIY Repair
Oldsmobile Intrigue Removing and Installing Speakers Oldsmobile Intrigue Front Door Speaker Removal and Installation 1.1) Remove one torx screw from door panel. 2.1) Pry panel from inside door opener. 3.1) Removed one exposed screw from panel removal. 3.2) Remove panel, disconnect connector and set to side. 4.1) Lift control panel releasing clips. 4.2) Remove connector from panel and set to side. 4.3) Remove one exposed torx screw from panel removal. 5.1) Pull door panel from door releasing 12 clips. 6.1) Disconnect connector for tweeter. 7.1) Remove four screws securing speaker to door panel.
Oldsmobile Intrigue Rear Speaker Removal and Install Oldsmobile Intrigue How to Remove and Replace Rear Deck Speakers 1.1) Pull two rings, one each at bottom of rear seat bottom cushion. 1.2) Lift rear seat from front of cushion and remove. 2.1) Remove bolts at bottom of rear seat back cushion securing seat belts and rear back seat cushion. 3.1) From trunk, release rear seat release switch freeing cable. 4.1) Pull rear seat backs down. 4.2) Remove four screws securing rear seat locks. 4.3) Pull rear seat frame from back of car forward. 5.1) Release three clips along front edge of package shelf cover. 6.1) Feed seat belt strap through slit in panel. 7.1) Push down on both sides of package shelf panel releasing clip guides from side panels. 7.2) Pull rear package shelf panel toward front of car. 8.1) Four screws secure each 6" X 9" speaker to rear deck.
Oldsmobile Intrigue Wire Diagrams and Wire Color Codes   Wire Diagrams, Cadillac, Chevrolet, Corvette, Geo, GMC, Oldsmobile, Pontiac and Saturn. DO NOT CUT FACTORY WIRE HARNESS     Aftermarket stereo installation? Why purchase the aftermarket wire harness? Installation is easier, no guess work with wire color codes and a Headache Saver! Factory wire colors codes are not universal. See Aftermarket Videos above. We discourage cutting the factory wire harness. This section aids in troubleshooting and determining wire color codes, phasing for speaker hook up, locating power wires for installing external devices and add-ons. Diagrams may not be applicable to Bose Audio Systems     IMPORTANT - There are two (2) yellow*, two (2) gray and two (2) brown wires in this harness. Locate the +12 volt constant wire first. Label it or splice to constant wire on aftermarket stereo first. Swapping yellow wires will cause damage to any aftermarket stereo. Check fuses if your unable to find +12 volts. 1   Gray Left Front Speaker (-) 2   Tan Left Front Speaker (+) 3   Dark Green Right Front Speaker (-) 4   Light Green Right Front Speaker (+) 5   Black Ground 6   Brown Illumination 7   Gray Dimmer 8   Blank   9   Yellow* (Green) Switched +12 volts 10   Orange Constant +12 volts 11   Light Blue Right Rear Speaker (-) 12   Dark Blue Right Rear Speaker (+) 13   Yellow Left Rear Speaker (-) 14   Brown Left Rear Speaker (+)     All wire diagrams and color codes are not 100% accurate.
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You