Porsche 911 Car Audio - Car Radio Removal | |
![]() |
Porsche 911 |
![]() |
1.1) Gently pry bottom left corner of trim panel from dash releasing clips. All clips release with pressure. |
![]() |
2.1) Gently pry top left corner of trim panel from dash releasing clips. |
![]() |
3.1) Gently pry top right corner of trim panel from dash releasing clips. |
![]() |
4.1) Gently pry bottom right corner of trim panel from dash releasing clips and entire trim panel from dash. |
![]() |
5.1) Pull top edge of trim panel down for access to top connector on left side. Release connector from trim panel. |
![]() |
6.1) Release second connector on left side of trim panel. |
![]() |
7.1) Release third connector on left side of trim panel. |
![]() |
8.1) Release top connector on right side of trim panel. |
![]() |
9.1) Release second connector on right side of trim panel. |
![]() |
10.1) Release third connector on right side of trim panel. |
![]() |
11.1) Release fourth connector on right side of trim panel. |
![]() |
12.1) Pull bottom left connector to side for access to mounting screw. Remove mounting screw. |
![]() |
13.1) Pull bottom right connector to side for access to mounting screw. Remove mounting screw. |
![]() |
14.1) Gently pull top left connectors to side for access to mounting screw towards back of car stereo. Remove mounting screw. |
![]() |
15.1) Gently pull top right connectors to side for access to mounting screw towards back of car stereo. Remove mounting screw. |
![]() |
NOTE routing of wired connectors through openings on exposed panel. Connectors will have to be routed through correct opening for reinstallation of trim panel. |
![]() |
16.1) Gently pry each side of AC vent assembly to release. |
![]() |
17.1) Remove AC vent assembly and set to side. |
![]() |
18.1) Pull car stereo forward from dash releasing clips. |
![]() |
19.1) Remove car stereo from dash. |
![]() |
20.1) Release trigger on connector to disconnect. |
![]() |
21.1) Release trigger on connector to disconnect. |
![]() |
22.1) Release trigger on connector to disconnect. |
![]() |
23.1) Release trigger on connector to disconnect. |
![]() |
24.1) Release trigger on connector to disconnect. |
![]() |
25.1) Release trigger on
connector to disconnect. 25.2) Remove car stereo. |
Front and Rear Speaker Removal presently not available. | |
Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up |
|
NO AUDIO With aftermarket stereo installation? |
|
Erratic Volume Control DIY Repair |
|
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You
|
|