| Saab 93
How to Remove and Replace Door Speaker |
 |
Do It Yourself Saab 93
How to Remove Door Speaker Instruction |
 |
1.1) Locate door panel
clip at end of door panel. |
 |
2.1) With small screwdriver,
push center of pin in to release clip. |
 |
3.1) Pry clip from door panel. |
 |
4.1) Removed clip with center pin pushed in. |
 |
5.1) When reinstalling clip, push center pin back through
clip. |
 |
6.1) Mount clip back into opening on door panel. |
 |
7.1) Push center pin in to lock clip into place. |
 |
8.1) With T27 remove screw along bottom back edge of door
panel. |
 |
9.1) Remove remaining screws along bottom of door panel. |
 |
10.1) Pry edge of small cover from door handle cavity. |
 |
11.1) Remove small cover and set to side. |
 |
12.1) Remove exposed screw. |
 |
13.1) At top edge of triangular panel at front of door,
push center pin on clip in to release clip. Note -
these center pins need to be pushed completely through clip to release.
You will have to locate this pin after removal of door panel to reinstall
clip. |
 |
14.1) Pry clip from panel. |
 |
15.1) Remove clip and set to side. |
 |
16.1) Release center pin on second clip. |
 |
17.1) Pry clip from panel to remove. |
 |
18.1) Pull edge of panel from door for access to back of
panel. |
 |
19.1) Release trigger on connector to disconnect. |
 |
20.1) Remove panel and set to side. |
 |
21.1) Center pins from clips will have to be located for
reinstallation of clips. Note - pins may be found
at top of door panel after being pushed through clip. |
 |
22.1) Pry edge of door handle releasing clips. |
 |
23.1) Pry along edge of door handle releasing clips. |
 |
24.1) Remove door handle panel and set to side. |
 |
25.1) Remove exposed screw at bottom of door handle. |
 |
26.1) Remove exposed screw at top of door handle. |
 |
27.1) Grasp door open handle. |
 |
28.1) Remove door open handle from door panel. |
 |
29.1) For reinstallation of door open handle, locate tab at
back of panel. |
 |
30.1) When pushing door open handle into place, tab on
panel must mate to loop in door handle linkage. |
 |
31.1) Pry front edge of door panel from door releasing
clips. Door panel clips release with pry pressure. |
 |
32.1) Pry along remaining edges of door panel releasing all
clips. |
 |
33.1) Remove door panel from door. |
 |
34.1) Lift back edge of door panel up over door lock pin to
release. |
 |
35.1) Pull top edge of door panel down for access to trunk
release switch. |
 |
36.1) Locate switch on back of door panel. |
 |
37.1) Squeeze outside edges of connector in to release
switch. |
 |
38.1) Push switch through front of door panel. |
 |
39.1) Lift trigger on edge of connector. |
 |
40.1) Remove trunk release switch and feed connector back
through opening in door panel, remove door panel and set to side.
Note - Locate any remaining pins from steps 13-21. |
 |
41.1) Check door for any remaining door panel clips. |
 |
42.1) Pry clips from door to release and remove. |
 |
43.1) Slide end of door panel clip into corresponding
holder on door panel ready for reinstallation. |
 |
44.1) This was not a premium sound system for Saab, no
speaker was present in this vehicle. |
 |
45.1) During reinstallation of door panel, feed trunk
release switch connector back through door panel and connect switch. |
 |
46.1) Push connected trunk release switch back into opening
to lock into place. |
