MR2 / Spyder Car Audio - Car Radio and Speaker Removal
	Toyota MR2 Spyder Car Stereo Removal Instructions NOTE -  Yes, this is an aftermarket car stereo. Removal instructions will apply.
	1.1) From bottom of each side of car stereo, side rails, pull plastic cover from mount.
	2.1) Remove two exposed screws from each side of dash.
	3.1) Pull bottom edge of panel away from dash.
	4.1) Push side panel slightly up then down to release.
	5.1) Remove lower screw from each side of car stereo.
	6.1) Remove upper screw from each side of car stereo. 6.2) Pull car stereo from dash, disconnect antenna and release trigger on connectors to disconnect.
	Aftermarket Car Stereo Installation
	Aftermarket Car Stereo Wire Color Codes
	Factory Wire Harness, Color Codes and Aftermarket Installation
	Speaker Phasing Installing Aftermarket Speakers and Proper Hook-up
	NO AUDIO With aftermarket stereo installation?
	Erratic Volume Control DIY Repair
Car Stereo Repair Home | Car Stereo Removal | Contact | Books 4 You